I have had this generator for some time but never had a manual. I like that It can put out 40vpp with both negative and positive DC offsets. The top of the sine wave is showing a very slight peak (as if triangular). I would like to give it a thorough calibration.
Does anybody have a manual for it?
Any ideas where to find one?
I sent a note to Interstate Electronics in Anaheim, Ca. May be the same company or purchased a long time ago by somebody else. Hope I get lucky.
Alfredo
Does anybody have a manual for it?
Any ideas where to find one?
I sent a note to Interstate Electronics in Anaheim, Ca. May be the same company or purchased a long time ago by somebody else. Hope I get lucky.
Alfredo
An externally hosted image should be here but it was not working when we last tested it.
Interstate was acquired by Racal Dana. You might give them a shot. I did considerable consulting work with them at the Anaheim factory, but yours looks to be a fully analog model. All my experience was on a fully programable 15MHz 845 model. At one time Bill Bowden was their head line tech, but that was decades ago.
Best of luck to you.
Doc
Best of luck to you.
Doc
Seems they've since been sold/merged/stolen by L-3. Try contacts at this link and ask for info on legacy products.
Doc
military gps, gps receivers, rugged displays, gps navigation, instrumentation systems, sws engineering services from L-3 IEC, ruggedized displays, smart bombs, smart munitions
Tucker also seems to have the manual if you have to give in and pay for it.
Interstate Electronic Corp Manuals from Tucker Electronics (At bottom; series 40)
Doc
military gps, gps receivers, rugged displays, gps navigation, instrumentation systems, sws engineering services from L-3 IEC, ruggedized displays, smart bombs, smart munitions
Tucker also seems to have the manual if you have to give in and pay for it.
Interstate Electronic Corp Manuals from Tucker Electronics (At bottom; series 40)
Last edited:
Thanks Doc,
L-3 is whom i tried contacting by email. I wil try giving them a call.
The link to Turker is helpful, i wiil contact them as well to verify the manual they sell is a service manual.
Alfredo
L-3 is whom i tried contacting by email. I wil try giving them a call.
The link to Turker is helpful, i wiil contact them as well to verify the manual they sell is a service manual.
Alfredo
Finally found one cheap. Covers the whole series 40 units. When I have time i will scan it and post it.
Hello avincenty,
I've been searching for a manual for an Interstate F44 High Voltage Sweep Generator and was fortunate enough to find your post from 2012. You mentioned that you might scan and post manuals for the whole 40 series. I was wondering if this is something you were able to do. I'm new to this site (joined just to write to you) and was unable to find anything. If it's not inappropriate, could I request that you scan and post the schematic for the F44. Yes, I know I could probably buzz it out, but I'm getting too old to spend my time like that.
Thanks in advance,
Terry
I've been searching for a manual for an Interstate F44 High Voltage Sweep Generator and was fortunate enough to find your post from 2012. You mentioned that you might scan and post manuals for the whole 40 series. I was wondering if this is something you were able to do. I'm new to this site (joined just to write to you) and was unable to find anything. If it's not inappropriate, could I request that you scan and post the schematic for the F44. Yes, I know I could probably buzz it out, but I'm getting too old to spend my time like that.
Thanks in advance,
Terry
- Status
- Not open for further replies.