Internal crossover blow

[hipyo]

Thanks you guys I can't get to it till I get back from traveling ,but I will try the soldering after I get back thanks for the advice those guys Thanks to all!! be back on the 22

 

[Dr. Photon]

sometimes the switch itself will go out. You know its the switch if you've resoldered all the connections around it, and it still goes out, but playing around with the switch does something. You could find a new switch, but it's probabally easier to permanently solder the damn thing in low pass.

 

[hipyo]

so its the switches fault?..... ok... ill see if resoldering and soldering lowpass permanently helps I think the switch works its not that old wut could go wrong with it?

 

[hipyo]

ok i just jingled the switch again and it works I don't know if it was that I was gone for 5 days but it works again I will do the soldering this weekend i got school tomorrow I may just keep jingling thie switch.... im lazy

 

[hipyo]

ok I took off the switch and soldered up the lowpass and it still distorts..... im getting pissed now so someone please help me before I throw the amp away!!

 

[ocool_15]

if you go back to all pass does it work fine? distortion on both channels?

 

[hipyo]

umm i cant check now that i took off the switch but it did work when the switch was on no distortion from any channel on both high pass and regular amp

 

[hipyo]

OK i am giving up on this amp now both channels are out that means i'll have to solder the switch back on which means back to regular amp....I will start a new thread on what amp i should buy from now on.....