Hi there had the folowing question. how to overcome the output increase when frequency goes up. what is the simple solution?
caus i've read serveal people only use a cap in there crossover, but there is also this rise in output the higher the frequency ? or am i complete going nuts on this one
i thought there whas this network to compensate for this but im not sure anymore.
caus i've read serveal people only use a cap in there crossover, but there is also this rise in output the higher the frequency ? or am i complete going nuts on this one
i thought there whas this network to compensate for this but im not sure anymore.
Could you tell us a little bit more about the type of transducer you are asking about?
Is it a ribbon or ESL? Is it a point source or a line source?
- electrical segmentation (e.g. like audiostatic)
- adding R, primairy or secundairy from the trannie
Can't say which is the best. You'll need the response curve of the trannie anyway
- adding R, primairy or secundairy from the trannie
Can't say which is the best. You'll need the response curve of the trannie anyway
- Status
- Not open for further replies.