Improving my OB midbass

A nearfield measurement is not able to show dipole peak or anything else related to dipole behaviour. Indoor measurements of midbass are very difficult, there will always show room modes and reflections. Speaker almost in middle of the room ointing to corner, mic at 60-100cm distance is best. Mic on the floor would be even better, but it's difficult to have the driver pointing down...

For analysis try various gating times 20-100ms and use smoothing 1/2 or 1/3 oct. Don't worry about small wiggles, they are artefacts! Edge of VCAD2 simulations are for sanity check.

Beyma with eq xo 1m vs floor.jpg Beyma 12MW near vs 80cm no eq xo.jpg
 
Last edited:
Interesting. Seems Kreskovsky's method suggested earlier isn't as accepted as I had interpreted.

I went ahead with naked 18" midbasses raised 8" from the floor, ran the Acourate correction routine, reduced the gain from the subs, and sounds a lot better. Happy camper!

I thought I would see a large drop in the peak at 250Hz and subsequent drop by 280Hz, but it wasn't the case: measurements at the listening position, before correction, with psychoacoustic smoothing. Green is with U baffle, blue is nude.
freq response psycho 2-7 vs 20-7.png


the peak is still there. Something else must be causing it.

But it does sound significantly better!

In the coming days I will measure as recommended.