Hello,
I need a schematic 5532 preamplifier four-five gain.
I already have 5532...🙄 Has anyone tried a simple preamp project?
THX
I need a schematic 5532 preamplifier four-five gain.
I already have 5532...🙄 Has anyone tried a simple preamp project?
THX
I don't want to buy a kit from China. I don't need tone control, just a scheme put into practice by someone.
Here is a fully tested op-amp preamp kit from ESP (Elliott Sound Products). It uses OPA2134, but you could substitute an NE5534, most likely with no changes needed. https://sound-au.com/project88.htm
It will also need a +/-15V DC power supply, perhaps like this: https://sound-au.com/project05d.htm
I hope that helps.
It will also need a +/-15V DC power supply, perhaps like this: https://sound-au.com/project05d.htm
I hope that helps.
NE5534 is different from 5532. 5534 has different pinout than 5532 and is single channel, while 5532 or OPA2134, LM4562 or 4558 are dual channel.
https://www.google.com/search?q=ne5...pzCXAQ_AUoAXoECAUQAQ&biw=412&bih=750&dpr=2.63Hello,
I need a schematic 5532 preamplifier four-five gain.
I already have 5532...🙄 Has anyone tried a simple preamp project?
THX
I built this from Rod Elliot: https://sound-au.com/project97.htm
It works very well. I used 5532s. I set the overall gain very high as I had a very low output DAC and not quite enough gain in my 3 way active speakers. I had to be careful about wiring as it would oscillate at high volume settings. I have since fixed the wiring, DAC and speakers and am delighted at the result.
It works very well. I used 5532s. I set the overall gain very high as I had a very low output DAC and not quite enough gain in my 3 way active speakers. I had to be careful about wiring as it would oscillate at high volume settings. I have since fixed the wiring, DAC and speakers and am delighted at the result.