Hi - I have an nCore based power amp which is stuck in bootloader mode, even when I power cycle the system. This all happened when I was updating the firmware and control firmware. It seems the firmware update completed successfully (v2.3) but the control firmware (v1.4, 1.5b, and 1.6b) produce a CRC error and tries to reload, endlessly. Any thoughts on what steps I might take to break out of bootloader mode? Many thanks
What amps you have? Hypex NCore amps don't based on firmware, that's usually some additional electronic (DSP etc.) around the amp that using firmware, I guess.
Hello,
You may want to contact Hypex customer service / tech support. They were quite helpful for me when I contacted them. Not terribly fast, but exactly the help I needed.
Can contact them thru their web site pages.
You may want to contact Hypex customer service / tech support. They were quite helpful for me when I contacted them. Not terribly fast, but exactly the help I needed.
Can contact them thru their web site pages.
