HV +B Connector

[Bengali]

Hi,

what you suggest for +B (300-400V) for a connector(jack and plug)

I was looking at the Neutrik powercon but I don't think they are rated
beyond 250V.

I would like to house the PSU seperate from the main tube pcb.

Is there any issue with running seperate DC heater as well?

Is 2 feet too long for the HV power cable?

Thx

 

[Vinylsavor]

Hi!

I use Amphenol MS series connectors. They are available with various numbers of pins.

I routinely use external PSUs. No probelm to also have the DC heater supply external. I always keep the last LC stage for each voltage in the amp chassis. Even long umbilical runs are no problem this way

Best regards

Thomas

 

[Bengali]

Do you use 2 or 3 conductor, shield?

I guess for H.V. it is better to use Teflon twister pair?

Excellent advise. Thanks.

 

[quadtech]

You can also consider an octal plug on the umbilical, plugging into
a female socket on the chassis.

8PB Cinch 5935-00-061-7250 Octal Plug-in Socket

 

[Vinylsavor]

Hi!

Do you use 2 or 3 conductor, shield?

Depending on the number of voltages I have, I use 5, 7 or up to 10 pin connectors.

Minimum is 5:

B+
Ground
2 wires for heater
safety earth


I use umbilicals with a common shield around all conductors. I connect the shield on the PSU side to saftey ground.

Best regards

Thomas