ok what would u like how is a photo gonna help>?>
its on linear web site.. no shcems jon wont provide..
what kind of measurements you want??
as far as i can tell the input goes to a opa 1632.. why? i dunno.. he's not using true balanced inputs.. then to the cs3318 then to dac..IIFRC
I can measure pin 2 inout to pin one output as a short.. ??? why?
its on linear web site.. no shcems jon wont provide..
what kind of measurements you want??
as far as i can tell the input goes to a opa 1632.. why? i dunno.. he's not using true balanced inputs.. then to the cs3318 then to dac..IIFRC
I can measure pin 2 inout to pin one output as a short.. ??? why?
i was hoping somebody here that had been fooling with these things for a few year that may have run into a didden board could shed some light..
I think you've asked the same questions over and over. This thread has run its course. If anyone wants to help you, they can reach you by PM or (if you activate it in your control panel) email.
Have you done any fault tracing? Can you locate where the trouble might be? All voltages correct? Wiring correct? Have you done any work by yourself? Done any quality check of your work? Do you have the proper documentation?
- Status
- Not open for further replies.