HP 339A oscillator problem

Status
Not open for further replies.
Interesting. These two resistors are both 24.9K on my schematic. No worries. Let's repeat a VM test from a while back: if you place VM leads between TP1 and U3C pin 9, difference should be less than 10 mV. Same should be true at TP2 vs. U5D pin 9.
 
Sorry to hear of continuing troubles.

TP2 obviously not working, highly probable TP1 not working either. It you'd like to trouble shoot without resorting to component removal, we try.

As a check for at least partial opamp health, try measuring U3B (i.e.TP1) by using meter probe to join pins 7 and 6 simultaneously. This will produce unity gain and you should see 0V on meter if that opamp section is operable. Try same procedure at U5B.

If these checks look good, would you report opamp U3C voltages at +,-, and output pins, and Q1 base and emitter voltages? Similary, U5D and Q2?
 
Status
Not open for further replies.