Hi new member here 🙂 I like the idea of modding my muse mini tda1543 dac especially after buying a much more espensive dac that did not perform aswell.
I figure since I have virturally no exp with working on electronics. I should start by simply replacing the "wall wart" with a better power supply. The wall wart is 12 volts 1 amp.
Btw I am in the USA,I am using a tube integrated and sumwhat "laid back" speakers.
I figure since I have virturally no exp with working on electronics. I should start by simply replacing the "wall wart" with a better power supply. The wall wart is 12 volts 1 amp.
Btw I am in the USA,I am using a tube integrated and sumwhat "laid back" speakers.
Linear, Battery or Switch Mode?🙂
Whatever you choose there will be some onboard regulation I would imagine, if the output of the wall wart is clean, then keep that, though depending on level of manufacturing quality the only way you can guarantee that is through measurement, though in the USA the FCC are more pro-active than the CE in europe.
Have fun, and have a look around at some of the discussions on power supplies, they can be fun.
Whatever you choose there will be some onboard regulation I would imagine, if the output of the wall wart is clean, then keep that, though depending on level of manufacturing quality the only way you can guarantee that is through measurement, though in the USA the FCC are more pro-active than the CE in europe.
Have fun, and have a look around at some of the discussions on power supplies, they can be fun.
- Status
- Not open for further replies.