How to control a eballast from IBM projector in a JVC projector ?

[Sebka33]

Hi everybody,
First, sorry for my english... I hope you'll understand me 😀

I have a JVC DLA-G10E projector, with original lamp dead.
I need to put an UHP (SHP) bulb into the reflector for replacing the very hot (and very expensive) 400w xenon lamp.

So, I bought a IBM iLC200 to take his eballast and put it on JVC projector. With 280w UHP bulb, it will be good.

But...
I think the e-ballast controller signal and voltage are not the same between JVC and IBM.

This is the block diagram from Service manual of IBM iLC200 :
http://www.idoxi.com/images/upload/IBMc200_diagram.jpg_s.jpg
http://www.idoxi.com/images/upload/IBMc200_alim_CM.jpg_s.jpg

And this is an image of JVC diagram :
http://img40.imageshack.us/img40/329/schembloc.jpg
(bypass = "SW5VRST" + "LAMPRET")

A suggestion 😕 ?
Please...

Can you tell me if I'd asked for some help in wrong section ?

Bye !

 

[Sebka33]

I found the answer to my question.

 

[ywh]

is this your need？