I have two questions in my circuit.
1) How to define the transformer primary and secondary turns ratio in the center-tapped transformer. My transformer turns ratio is 8:2 (step-down) transformer.
Should I mention like Primary Turns - 8 and Ratio to primary1 - 2
(OR)
Primary Turns - 8 and Ratio to primary1 - 250m
Which one is correct one?
2) As, I mentioned previous mail....
In the document given that how to add the .PARAM netlist lines for Resistor and Capacitor. There not talk about how to add the netlist for switching frequency and duty cycle. So, in my case I have to add the .PARAM netlist for my Switching frequency of 3MHz and 50% Duty cycle.
How to add the netlist for frequency and duty cycle? And also provide me the processor how to follow in order to add them?
Please, provide me the answers as soon as possible.
Here, I have attached the my circuit.
1) How to define the transformer primary and secondary turns ratio in the center-tapped transformer. My transformer turns ratio is 8:2 (step-down) transformer.
Should I mention like Primary Turns - 8 and Ratio to primary1 - 2
(OR)
Primary Turns - 8 and Ratio to primary1 - 250m
Which one is correct one?
2) As, I mentioned previous mail....
In the document given that how to add the .PARAM netlist lines for Resistor and Capacitor. There not talk about how to add the netlist for switching frequency and duty cycle. So, in my case I have to add the .PARAM netlist for my Switching frequency of 3MHz and 50% Duty cycle.
How to add the netlist for frequency and duty cycle? And also provide me the processor how to follow in order to add them?
Please, provide me the answers as soon as possible.
Here, I have attached the my circuit.
