How can this speaker run on portable power consisting of 8 AA's batteries?
is it 3 watts? does it have a hidden 12V SLA battery? or does it run for 10 minutes?
I don't get it?
410mA draw?
Current Draw 410 mA
Expected battery life under continuous use Alkaline: approx. 8 hours (MAX), approx. 12 hours (ECO)
Nickel-metal hydride: approx. 10 hours (MAX), approx. 15 hours (ECO)
* These figures will vary depending on the actual conditions of use
BA-330 :: Products :: Roland
Roland BA-330 Stereo Portable PA System | Musician's Friend
is it 3 watts? does it have a hidden 12V SLA battery? or does it run for 10 minutes?
I don't get it?
410mA draw?
Current Draw 410 mA
Expected battery life under continuous use Alkaline: approx. 8 hours (MAX), approx. 12 hours (ECO)
Nickel-metal hydride: approx. 10 hours (MAX), approx. 15 hours (ECO)
* These figures will vary depending on the actual conditions of use
BA-330 :: Products :: Roland
Roland BA-330 Stereo Portable PA System | Musician's Friend
Yeah, it's a very efficient 2-channel class D or T 5 watt mostly vocal speach P.A. using small efficient speakers and horns, without much bass. Average power is probably a fraction of a watt, thus the optimistic battery life figures. Now if you play compressed music loud then battery life will be very very poor. The power supply is 12 V but the 8 AA give 17.6 at 2.2 each X quantity 8. It appears to be stereo.
Could be cool for a street performer with an Optima car battery.
Could be cool for a street performer with an Optima car battery.
You notice it takes "battery pack for quick reload"... So they really expect you to have multiple batery packs and swap them.
"is it 3 watts? "
Most likely: Class D bridge amp, 12W/4Ω.
http://www.e-ele.net/DataSheet/TA2020.pdf
Most likely: Class D bridge amp, 12W/4Ω.
http://www.e-ele.net/DataSheet/TA2020.pdf
Last edited:
They could, but I doubt it. The loss of efficiency of the inverter would lower the overall battery life.
I would bi-amp the speakers and get more output that way.
I would bi-amp the speakers and get more output that way.
Well they could get 95%+ from the converter I think, if properly designed, and it would also keep the voltage to the power amp constant even as the batteries start to lose charge. I doubt it too, but it's possible.
- Status
- Not open for further replies.
- Home
- Amplifiers
- Solid State
- How is This Possible???