• WARNING: Tube/Valve amplifiers use potentially LETHAL HIGH VOLTAGES.
    Building, troubleshooting and testing of these amplifiers should only be
    performed by someone who is thoroughly familiar with
    the safety precautions around high voltages.

Hot Rodded Dynaco ST-35 - Dynakit Parts Kit

Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
Jump to Latest
HiGHFLYiN9s

HiGHFLYiN9s

Member
Joined 2010
zynsonix.com
Just finished up a fun build of a Dynaco ST-35 amplifier. This one in particular was the Dynakit Parts Build. I included some fun stuff including:

  • Teflon tube sockets with Beryllium copper contacts
  • Ceramic gold plated driver tube sockets
  • Mundorf and Obbligato driver board capacitors
  • Solen power bypass caps
  • Kimber TCSS internal wiring
  • Kiwame / Koa Speers carbon film resistors
  • Hammond 156R Choke - 56ohms DCR
  • Dynakit Parts ST35 BCU (Bias Control Unit)
  • Front power switch
  • Triode / Ultralinear Switches
  • Cardas RCAs and Binding Posts
  • C8 power inlet jack with custom C7 power cord
  • Custom powdercoat color-scheme
  • Alternate fuse holder and placement
  • Custom Brass Engravings


Here's a few pics:

Dynaco-ST35-Complete-2.jpg



Dynaco-ST35-Complete-Back.jpg



Dynaco-ST35-Inside-D.jpg



Full build notes and pics are in the usual place: DIY Audio Electronics from Zynsonix.com: A Customized Dynaco ST35 Kit
 
Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
Top Bottom