Buzzy said:Can a speaker cable like canare 4s11 be used as a wire for internal wiring of a DIY amplifier ? I see that on canare website it states that it can be used for DC power line.
I need your opinion on this .
Thankz.
So long as you use a good quality cable you should be fine.
Some cheap cable can be quite resistive.
I did a project for a surveliance system using cameras on quite long runs of wire. I did some research into different cables and was surprised at how good some cable is and how bad others are for voltage drop.
Buzzy said:Can a speaker cable like canare 4s11 be used as a wire for internal wiring of a DIY amplifier ? I see that on canare website it states that it can be used for DC power line.
The simple answer is 'yes, it should be fine'.
Re: Re: Hookup wire
So long as it can carry the maximum current in the amp.
Gordy said:
The simple answer is 'yes, it should be fine'.
So long as it can carry the maximum current in the amp.
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- Amplifiers
- Solid State
- Hookup wire