Would it be possible to use a highly conductive spray like this ([url]http://www.lord.com/products-and-solutions/brands/ultraconductive)[/URL] to make a planar magnetic trace on a sheet of Mylar?
Any other spray on options?
Any other spray on options?
Their documentation doesn't state what the conductivity is of their product is.
I have tried conductive inks and they don't stick to Mylar very well or at all for the most part.
They are very difficult to work with and expensive.
It was very hard in my experiments to get a useful very thin and light weight low resistance coating, and I did use Mylar and it just peeled right off when it was bent or flexed.
jer 🙂
I have tried conductive inks and they don't stick to Mylar very well or at all for the most part.
They are very difficult to work with and expensive.
It was very hard in my experiments to get a useful very thin and light weight low resistance coating, and I did use Mylar and it just peeled right off when it was bent or flexed.
jer 🙂
Last edited:
- Status
- Not open for further replies.