Photo shows an example how power supply boards looks after assembling.
An externally hosted image should be here but it was not working when we last tested it.
Hi supernet,
The PCBs did arrive today 🙂, fast delivery 😀, nice PCBs great looking 😀, very well packed 😎, all OK 🙂! Thank you 🙂😀!
Best regards
rephil
Nice !
I'd like 2 boards please. They look ideal for a rectification & pre-smoothing board for some filament supplies for big valves ( tubes ) eg. GM70 .
Looks like they have 10mm lead spacing for the caps, yes ?
I will e-mail you on the supplied address.
I'd like 2 boards please. They look ideal for a rectification & pre-smoothing board for some filament supplies for big valves ( tubes ) eg. GM70 .
Looks like they have 10mm lead spacing for the caps, yes ?
I will e-mail you on the supplied address.
Not possible...but...center tap is actually a joint of two wires together. If you can manage to split them apart, then this psu board is OK for you. If not...you need new transformer for this particular board 😉
I just soldered one of these together yesterday. Those wide tracks take a lot of heat. The result is very nice, as can be seen from the picture as well.
- Status
- Not open for further replies.