I am going to build a small pair of mobile speakers ie for moving out to BBQ table, work area etc etc
Am going to use vifa M10MD3906 mids with d20td0506 tweeters, half price from mass.com.....
I intend at this point (before testing) to simply use a series cap with the tweeter as a high pass at 8kHz (3.3uF)
The tweeter literature states a 2nd order xover should be used - I am assuming this would only be essential for a lower xover point.... is 8kHz high enough to only need a 1st order filter??
lee
Am going to use vifa M10MD3906 mids with d20td0506 tweeters, half price from mass.com.....
I intend at this point (before testing) to simply use a series cap with the tweeter as a high pass at 8kHz (3.3uF)
The tweeter literature states a 2nd order xover should be used - I am assuming this would only be essential for a lower xover point.... is 8kHz high enough to only need a 1st order filter??
lee
my problem is that the 10md's don't really sound that good up high (Ihave some) Use the second order...
I have routinely used 3.3's for tweeters, but it does
presume that you are not planning on playing too loud.
presume that you are not planning on playing too loud.
- Status
- Not open for further replies.