Not that I know of..perhaps you mean that balanced input connector (?) wich is at Hifonics amp on it´s place but not in GZ
Anyone? This doesn´t seem to fix with flashlight 😀
I already changed 2 opamps..is there a point to change rest of them too (at preamp)? How about a ´leaking´ capasitor, would that do something like that (at preamp)?
The weird thing is that signal seems to go into the driver board but doesn´t come out.......anyhow this same driver board works fine in another amp so issue is the most probably not there.
I already changed 2 opamps..is there a point to change rest of them too (at preamp)? How about a ´leaking´ capasitor, would that do something like that (at preamp)?
The weird thing is that signal seems to go into the driver board but doesn´t come out.......anyhow this same driver board works fine in another amp so issue is the most probably not there.
Not fixed yet 😀 :/
Does anyone know how those IRS21844 shutdown pin work? I have 100V supply at IRS and 93V at shutdown -pin....is this okay?
I´ve changed every opamp at preamp -section and at driver board, now situation is that signal goes to input pin on IRS but nothing comes out from IRS........
Does anyone know how those IRS21844 shutdown pin work? I have 100V supply at IRS and 93V at shutdown -pin....is this okay?
I´ve changed every opamp at preamp -section and at driver board, now situation is that signal goes to input pin on IRS but nothing comes out from IRS........
- Status
- Not open for further replies.