massimo:
Thank you both for the information and the offer! I may take you up on your translating services after I figure out which enclosures are needed for the next project.
Regards,
Scott
Thank you both for the information and the offer! I may take you up on your translating services after I figure out which enclosures are needed for the next project.
Regards,
Scott
WOW...thanks for this...I just ordered a 2U with heatsink for an aleph mini project and this link saved me some serious $$$...
Did you order it from France or from the Italian manufacturer directly? The latter could offer you a nice upgrade: bottom and top covers made out of thick aluminum instead of mild steel.
Just ask them! 😉
Edit: I forgot to mention the rear panel, also availeble in alu
Just ask them! 😉
Edit: I forgot to mention the rear panel, also availeble in alu
Last edited:
From the French site...they had all the options of the thicker front panels in silver and black too. The shipping was really the killer from Italy. It was half the cost from France - which is not chump change.
Thanks for the tip. Those chassis look beautiful. I've been thinking about ordering one but the shipping is a killer. How I wish they made something similar on this side of the pond!!
Those are std, the alu bottom and top aren't advertized yet AFAIK, but available on request.
Good! I had some bad surprise from other French suppliers with shipping cost 🙁
- Status
- Not open for further replies.