Hi folks, looking for help/advice on my 5532 buffer line driver

thanks monstercore. i will probably use your values. only thing i was thinking was to take out all the unwanted noise and DC before it goes through the opamp?

i guess i wanted to personalise it a bit so i didnt feel like a plagiarist haha 🙂 if it doesnt perform as well as your design perhaps i will just roll back to yours.
 
Hi folks any idea why im getting a DRC error for these Via's ? theyre just for the purpose of screwing the board to the chassis standoffs. i realise it probably doesnt matter and I can ignore it but im just curious. theyre all connected to the big blue ground plane, do I need to put traces on the top copper layer too? surely it doesnt matter if the ground plane connects all the grounds.. ?

Screenshot 2025-03-28 at 07.27.59.png
 
no theres no input pots. its just straight line in from interface. only pot is a 1k trimmer bridged between the two opamp noninv inputs to trim the gain.

you got a good point though , i didnt factor in input impedance. to be honest, I think im just going to build it with my chosen values and hotswap different components noting high freq response to taste on the scope? if its way off when testing the first channel, buying 24 more film caps isnt the biggest stress in the world