hello folks, looking for ideas to design 0.25 ohm stable mono amp. have 4 bose subs 10"neodymium magnets solid structure and flawless 1 ohm flat wire voice coil 150W, tested in series but i want more juice... thanks in advance ! 😀
0.25 ohm stable? Not gonna happen.
Instead put them in series for 4 ohm and multiply supply voltage by 2 to get 4 times the output power instead.
Instead put them in series for 4 ohm and multiply supply voltage by 2 to get 4 times the output power instead.
Use a big OPT (modify a mains trafo) to get whatever impedance you like. Keep the amp running at high voltage where its more efficient.
Iraud amp ? Have one of those around. But is rated at 150w is full range btw. Was thinking in h-bridge type with HIP4080AIP or some.
You can get irs2092 based amps up to 1700 watts.
Look up iraudamp7.
I designed one for myself that was 2000 watts bridge mode or stereo 1000+1000.
Look up iraudamp7.
I designed one for myself that was 2000 watts bridge mode or stereo 1000+1000.
- Status
- Not open for further replies.