Hello. I'm completly new to this forum and a severe novice when it comes to electronics repairs.
I have a Traynor 6400 series 2 powered mixer. After hooking it up to new speakers today, everything was fine and then a couple hours later when I went to use a new mic with it, there was suddenly no sound coming out. I have since learned that if I turn the volume and gain all the way up, I get just the absolute minimum amount of sound. The led gauge is working and is even going as far as to say it is nearing maxing out, but it can obviously go louder than this. I've tried both speaker outputs in the rear as well as the main output in the front.
Any help is appreciated. I have a multimeter and know how use it, but I don't know where to start. Thanks.
I have a Traynor 6400 series 2 powered mixer. After hooking it up to new speakers today, everything was fine and then a couple hours later when I went to use a new mic with it, there was suddenly no sound coming out. I have since learned that if I turn the volume and gain all the way up, I get just the absolute minimum amount of sound. The led gauge is working and is even going as far as to say it is nearing maxing out, but it can obviously go louder than this. I've tried both speaker outputs in the rear as well as the main output in the front.
Any help is appreciated. I have a multimeter and know how use it, but I don't know where to start. Thanks.