Hello,
I just received my R & S UPA3 analyzer
The "distortion measurement" part works very well
However when I measure the part "signal generator" I get a very high rate of distortion: 1.75%!
So I would like to recalibrate the "signal generator" part
is it very complicated?
Has someone here already done it
I have the manual sent to me by "audio king"
is it complicated from this manual to do this work?
Thanks
Alain
I just received my R & S UPA3 analyzer
The "distortion measurement" part works very well
However when I measure the part "signal generator" I get a very high rate of distortion: 1.75%!
So I would like to recalibrate the "signal generator" part
is it very complicated?
Has someone here already done it
I have the manual sent to me by "audio king"
is it complicated from this manual to do this work?
Thanks
Alain
Hi Letron,
I have no experience with your analyzer, but I believe I'be been able help a few people repair their HP339A analyzers. I'd enjoy the opportunity to study the R&S manual and offer suggestions if you can arrange for me to get a PDF copy. I enjoy studying well-designed test equipment.
Good luck!
I have no experience with your analyzer, but I believe I'be been able help a few people repair their HP339A analyzers. I'd enjoy the opportunity to study the R&S manual and offer suggestions if you can arrange for me to get a PDF copy. I enjoy studying well-designed test equipment.
Good luck!
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- Design & Build
- Equipment & Tools
- HELP UPA3 Re-calibration