Okay, I am in a bit of a panic. I need to throw a system together in the next couple days. I have a Peavey XR696F(2x600 Watts) Powered Mixer and would like to connect a Tapco J800. My hope is to use the 2 amps from the powered amp to run FOH and the Tapco to run a couple monitors. The XR696 has the following 1/4" connection:
Ft. Sw EFX Defeat, Line OUtputs-Monitor/Left Mono/Right,
Power Amp In-Left/Right
So that is 6 connections in all.
What I would I run from the Peavey to connect into the Tapco to get the setup I am hoping for? Here is a link to the back of the Tapco.
Picture Viewer
Any help on this would be much appreciated.
Ft. Sw EFX Defeat, Line OUtputs-Monitor/Left Mono/Right,
Power Amp In-Left/Right
So that is 6 connections in all.
What I would I run from the Peavey to connect into the Tapco to get the setup I am hoping for? Here is a link to the back of the Tapco.
Picture Viewer
Any help on this would be much appreciated.
Not being into PA or knowing the Peavey XR696F, you should use the Line Outputs from the Peavey, and connect them to the Line Inputs on the Tapco 🙂
- Status
- Not open for further replies.