Hello,
This is my first post, and class-d amp project.
I Bought a ta2020 dc amplifier board off ebay, which came with wired inputs and output and a volume pot. I had a home in-wall center channel speaker with 2 4" mids and a 1" al. tweeter with +/- 3db switch. I have a bluetooth receiver board, and a car usb adapter I can scavenge for 12v to 5v step down.
I would like to have it powered by a battery or external dc input (laptop 12v 4A power supply), and if possible allow charging of the battery with the external power supply.
The main question I have at this time is how to convert the stereo to mono for the speaker, and any tips in general would be greatly accepted, thanks!
This is my first post, and class-d amp project.
I Bought a ta2020 dc amplifier board off ebay, which came with wired inputs and output and a volume pot. I had a home in-wall center channel speaker with 2 4" mids and a 1" al. tweeter with +/- 3db switch. I have a bluetooth receiver board, and a car usb adapter I can scavenge for 12v to 5v step down.
I would like to have it powered by a battery or external dc input (laptop 12v 4A power supply), and if possible allow charging of the battery with the external power supply.
The main question I have at this time is how to convert the stereo to mono for the speaker, and any tips in general would be greatly accepted, thanks!
Attachments
Thank you ledsscp7, would it be best to solder these resistors on the amplifier board, or make a new board?
- Status
- Not open for further replies.