Hi all,
So I'm trying to use Jeff Bagby's FRM program, and everything is working properly right up to the point I try to extract the phase from FRD file. The progress indicator stays at 1% and then Excel stops responding. I've already made sure the following:
-macros enabled
-both analysis toolpak installed
-fftdll file in default Excel folder along with said program and frd files
-Excel is 32-bit
-frd file extensions correct
Any suggestions?
So I'm trying to use Jeff Bagby's FRM program, and everything is working properly right up to the point I try to extract the phase from FRD file. The progress indicator stays at 1% and then Excel stops responding. I've already made sure the following:
-macros enabled
-both analysis toolpak installed
-fftdll file in default Excel folder along with said program and frd files
-Excel is 32-bit
-frd file extensions correct
Any suggestions?
Well, I managed to sort out the problem, it was a simple separator issue in Excel. However when I try to extract the phase from the tweeter zma file I have the same problem again. The progress stops at 1% and Excel stops responding. There's no problem when extracting phase from the woofer zma, but that file is created by the FRM whereas the tweeter file is just from a graph trace. I'll include the tweeter zma file if someone wants to take a look at it.
Have you tried deleting the header lines? If that doesn't work try loading it in Excel and save it as a tab separated file.
- Status
- Not open for further replies.