issue... I built this almost 2years ago and had been working fine until 2 hours ago... when I did some soldering to bypass C3 which is a non polar electrolityc -10 uf- with a film cap, which I have done before at least twice.
Connected it to my system and no sound at all. The leds in the Salas PS turn on ok, and the voltages are also ok. So, what could I have done wrong and what might have been damaged?
Does the fact that it occurs in BOTH channels give a hint? Thanks in advance.
Connected it to my system and no sound at all. The leds in the Salas PS turn on ok, and the voltages are also ok. So, what could I have done wrong and what might have been damaged?
Does the fact that it occurs in BOTH channels give a hint? Thanks in advance.
- Status
- Not open for further replies.