Hi all
A few days ago a friend of mine gave new a very nice vintage soldering iron.
Its an ADCOLA 24v, 50W, 50Hz, L444, Electronic Control Iron.
I would like to know how does one change the tip on this iron. It seems to be press-fitted as there is no screws that holds it nor any mounting device.
Any ideas appreciated!
A few days ago a friend of mine gave new a very nice vintage soldering iron.
Its an ADCOLA 24v, 50W, 50Hz, L444, Electronic Control Iron.
I would like to know how does one change the tip on this iron. It seems to be press-fitted as there is no screws that holds it nor any mounting device.
Any ideas appreciated!
Maker :-
L & M Products
The 444 tip is the same as the current K2000 range according to the site and fits with a Stainless steel shim - Pulls out?? maybe
Maybe an email to the makers will get an answer
alan
L & M Products
The 444 tip is the same as the current K2000 range according to the site and fits with a Stainless steel shim - Pulls out?? maybe
Maybe an email to the makers will get an answer
alan
Thank you Spiny!
I mailed them and they replied with a good amount of information. Seems there is still service backup for these old tools. Old but great.
I mailed them and they replied with a good amount of information. Seems there is still service backup for these old tools. Old but great.
- Status
- Not open for further replies.