I have an Alpine head unit with a built in eq/crossover . I set the eq on the headunit to flat . I wanna use a Rockford Fosgate symmetry epx2 for the preamp crossover and eq instead of the headunit since I can load different eq settings and at the push of a button I can switch setting depending on what type of music I listen to . Also I can set the boost to minimum at 45 hz if I don’t want so much bass instead of adjusting the eq settings all the time on head unit .
Wondering if using the symmetry with the head unit I have is causing the issue with low output out of the symmetry or there is an issue with the symmetry itself .
Any thoughts ?
Wondering if using the symmetry with the head unit I have is causing the issue with low output out of the symmetry or there is an issue with the symmetry itself .
Any thoughts ?
Two things you need to check...
1) Make sure the internal jumpers are set to RCA and not balanced (page 41 of manual).
2) Go through the levels setup to make sure it's set to match your HU output (page 33 of manual).
http://www.rockfordfosgate.com/rftech/library/1997/2_signal_processors/man0882c_epx2_man.pdf
1) Make sure the internal jumpers are set to RCA and not balanced (page 41 of manual).
2) Go through the levels setup to make sure it's set to match your HU output (page 33 of manual).
http://www.rockfordfosgate.com/rftech/library/1997/2_signal_processors/man0882c_epx2_man.pdf