As stated I purchased the ebay kit as seen on them here and there with the new PC boards and the like. So, Have only recapped the Hafler DH110 with success I then though to take this on. Long story short. I felt pretty good about my soldering job on it with no cold solders that I am aware of. It power on with a variac and have it up to 110. No fuses blown. Great. Get speakers on it and nothing. Not even fuzz sound. Wiggle the rca's and no sounds as well as speaker wires to hear that cracking sound when you hook them up. Just nothing. So, not knowing how to back track diag. Could someone walk my through what to check first and then the next to see what I hooked up wrong. Was working on old board and wires before.
Just to have full info.. I also rewired the entire amp as well and thought I followed the instructions to the letter.
Can get pics up if needed. Thank you for any help to this noob trying to be a one of this idiots to take these things on.
I do have a Fluke Multimeter if I could also know what setting to be on to check different parts of the amp out to diag my issue.
Geez, what a noob...
Just to have full info.. I also rewired the entire amp as well and thought I followed the instructions to the letter.
Can get pics up if needed. Thank you for any help to this noob trying to be a one of this idiots to take these things on.
I do have a Fluke Multimeter if I could also know what setting to be on to check different parts of the amp out to diag my issue.
Geez, what a noob...