Group Buy for LM4651/ 4652 Subwoofer Amplifier PCB

[spudspud]

oops (full range) bottom view😀

 

[DSchmidt]

Is anyone still interested in this? If there is sufficient interest, I'll organize the PCB purchase ...

 

[abcheng]

Would it be able to run at 2 ohms ? If it could run at 2 ohms, I could run one to each voice coil on my Adire Audio Brahma 12 🙂.

 

[PierreG]

Interesting project. Somebody knows the approximative price for all the requested components?

 

[aaronlow]

schamatic/layout files

Does anyone have the layout files that are used for this PCB. I would prefer the source files, and not Gerber files as I would like to add some features to the board.

I have access to a large number of PCB design tools to convert the files to.

When I am done updating the design, I will gladly upload the design for the fellow DIYers to use.

Thanks,
Aaron Low

 

[Primetime]

I'm interested too.. I'll confirm when the estimated price is known.

 

[SpittinLLama]

These chips are now on lifetime buy so if interested I would get what you want from National while you can.

The LM4651/52 set can run 2 ohms but current limit will kick in. Better to run no lower than 2.7 ohms. (8ohm // 4ohms).

-SL

 

[xaudiox]

im also interested with the group buy

 

[spudspud]

How would you run this chipset at 2 ohms as o/p filter is meant to be load matchin int it.🙂

 

[raypalmer]

Interested... but I'm confused. Is this for a 2.1 channel amp or for a sub amp?

If it's just a sub amp I'd be down for two.

 

[ben_lesmana]

Hello,

Im interested, but always depends on the price 😉

Hopefully no smd parts.

Regards,
Ben

 

[Nisbeth]

This thread is over three years old, so don't hold your breath while waiting 😉

/U.