Gerber help on mac
Ok. my mission is simple. I want to use Gerbv or something similar to check and panelise my boards for my KrellClone pcb project. I have found a port that runs on the Mac, but I have absloutely no idea how to install it!
Call me thick if you want, but I have just spent about 2 hours reading through various websites, and I have absolutely no idea what those geeks are talking about. It seems to be a case that I have to download about 50MB of files, install this, compile that, run something else, configure the first three things, compile several other things and then configure them, then deal with a program that seems to have no logic about it at all!
Help!!!!
Ok. my mission is simple. I want to use Gerbv or something similar to check and panelise my boards for my KrellClone pcb project. I have found a port that runs on the Mac, but I have absloutely no idea how to install it!
Call me thick if you want, but I have just spent about 2 hours reading through various websites, and I have absolutely no idea what those geeks are talking about. It seems to be a case that I have to download about 50MB of files, install this, compile that, run something else, configure the first three things, compile several other things and then configure them, then deal with a program that seems to have no logic about it at all!
Help!!!!
Thanks, for the suggestion P-A, but I'm using Eagle to generate the files, and I would prefer to test them with another programme, just to make sure! 🙂
If you could import gerber into Eagle I think it's something.
I could also import the files into my RUN.
I could also import the files into my RUN.
- Status
- Not open for further replies.