You need one board per rail unless you are doing the center tap trick, which I don't think you are. So you need two rectifier boards per psu.
Thank you very much for quick answer, but...Looks like a good plan! 😉
...only a good plan... or even something more? 😉 😀

Well anyone can screw up the soldering, but as you have drawn it, it will work.
Thanks!
BTW: do you plan F3 boards GB?
Well anyone can screw up the soldering, but as you have drawn it, it will work.
Hey, Christian,
I resemble that remark! 😱 🙂
Ron
Decided to get more boards?![]()
No, more amps!


P.S.
OK, indirectly you're right... 😉
hi christian just bought your bridge and psu what are the value of the resister r1 r2 r3 r4 on the bridge rectifier thank you for a fantastic job pierre😀
Thanks!
I have tried to answer that question in the first post of this thread - r1-r4 are the snubber resistors.
I have tried to answer that question in the first post of this thread - r1-r4 are the snubber resistors.
- Status
- Not open for further replies.
- Home
- Group Buys
- Gb: Rectifier boards