GB: AYA II TDA1541A DAC (2014 Edition) PCB or Kit

[northernsky]

Thank you Eldam, your suggestion was right: I'll get a pcb

northernsky

 

[acccruz]

WTB: AYA II DAC TDA1541A (PCB or Kit)

If anyone, please contact me. Thank you!

 

[triode_al]

There is (commercial) room for a new board that fits in with the simultaneous board: it is not sensible to use only half or two thirds of the board.
Perhaps demodulation (?) is different due to the simultaneous inputs anyway.

 

[cristianr]

If anyone still has the build manual for Aya II pcb please let me know.

 

[cristianr]

I found the manual. If anyone has an extra pcb please let me know in a pm. Thank you.

 

[agro0305]

Hi. Since this new version of the AYA-II will support I2S interface with U.FL miniature coaxial connector, I'm planning in using an external Asynchronous USB interface, much better than the one built-in on the AYA PCB.

I'm already using the very good Amanero in my HQ-9018 ESS Dac.
I designed a little carrier board with local LDO low noise regulators, I2S isolator (ISO7640FM chip) and U.FL output connectors. See included first version of this PCB. I'm planning in using the AYA-II Raw V+PCM supply and I won't install the AYA USB interface parts.

See the included schematic. I won't debate at large my parts choice that was partially done using parts I had in stock. The circuit architecture is inspired from the HQ-9018 PCB, that I know is working perfectly.

Since the TDA1541 is working on +5V and not +3.3V, I added a small jumper on the PCB to select the Isolator chip voltage 3.3 or 5V. There is separated GND, local decoupling, ferrite LC filters, etc...

Hi Algar,

Is there any way how I can obtain AYA-II Amanero board.

thanks in advance.

 

[nicoch58]

I have S1working AYA-II usb with is original Trafomaic toroid from Pedja ,if one want just pm...