Hey, guys.
I'm selling my complete Welborne Labs Alan Kimmel designed Mu Stage Driver kit for the Dynaco ST-70 from a few years back. I have a couple of Dynaco ST 70 power amps that I purchased this kit for, but I never got around to doing more than stuffing the boards and installing the mounting plate. I will send everything listed below to whomever purchases this kit. It retailed new for about $425 US including the following:
1x Driver PCB
1x Bias PCB
WIMA Metallized Film and Foil Capacitors
Kimber Caps
High quality (Dale/Vishy I think?) metal film resistors
all teflon coated high end copper hookup wire (Wonder wire)
All hardware including terminal strips screws etc...
1x Brand new Choke from Magnetek
2 NOS JAN (Joint Army Navy) 5751 tubes
2 NOS JAN (Joint Army Navy) 6U8A tubes
Custom Mounting Plate
4 9 pin tube sockets for installation in the mounting plate
I am asking $300 for the whole kit tubes and everything plus actual shpping and handling to your address. I accept Paypal as the form of payment.
PM me if you're interested.
In case the site goes down for the upgrade soon, you can Email me at ew6@nyudotedu if you're interested. Just replace the "dot" with a "."
I'm selling my complete Welborne Labs Alan Kimmel designed Mu Stage Driver kit for the Dynaco ST-70 from a few years back. I have a couple of Dynaco ST 70 power amps that I purchased this kit for, but I never got around to doing more than stuffing the boards and installing the mounting plate. I will send everything listed below to whomever purchases this kit. It retailed new for about $425 US including the following:
1x Driver PCB
1x Bias PCB
WIMA Metallized Film and Foil Capacitors
Kimber Caps
High quality (Dale/Vishy I think?) metal film resistors
all teflon coated high end copper hookup wire (Wonder wire)
All hardware including terminal strips screws etc...
1x Brand new Choke from Magnetek
2 NOS JAN (Joint Army Navy) 5751 tubes
2 NOS JAN (Joint Army Navy) 6U8A tubes
Custom Mounting Plate
4 9 pin tube sockets for installation in the mounting plate
I am asking $300 for the whole kit tubes and everything plus actual shpping and handling to your address. I accept Paypal as the form of payment.
PM me if you're interested.
In case the site goes down for the upgrade soon, you can Email me at ew6@nyudotedu if you're interested. Just replace the "dot" with a "."
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.