Most diyers here already know this fantastic sounding (and looking too) amplifier. I need only to say, that this one was handmade by constructor Andrej L. (Lazy Cat) himselves! Wiring and soldering inside, are simply piece of art. 😉
Here is the list, what this beautiful case include:
- 2 VSSA modules, assembled and calibrated for less than 1mV offset, Nichicon FG caps everywhere
-2 hot rodded Hypex SMPS 400A180 power supplies; input Samwhas replaced by 1500uF 200V Panasonic high current 105C series
- added soft start circuit with delay, NTC and high inrush relay
- teflon wiring, with crimped and soldered faston terminals
- case which is made of 5 mm aluminium, natural eloxated; all holes are laser cut; heatsinks are Fischer SK157 type
Price: 800 EUR + post costs
Few photos below:
Here is the list, what this beautiful case include:
- 2 VSSA modules, assembled and calibrated for less than 1mV offset, Nichicon FG caps everywhere
-2 hot rodded Hypex SMPS 400A180 power supplies; input Samwhas replaced by 1500uF 200V Panasonic high current 105C series
- added soft start circuit with delay, NTC and high inrush relay
- teflon wiring, with crimped and soldered faston terminals
- case which is made of 5 mm aluminium, natural eloxated; all holes are laser cut; heatsinks are Fischer SK157 type
Price: 800 EUR + post costs
Few photos below:
Attachments
To answers some questions:
Power output is 80W/8ohm and 140W/4ohm. This amplifiers was tested against NCore 400 and in case of timbre, musicality, 3D stage, vocals and headroom, the VSSA amplifier is clear winner here 😎
Power output is 80W/8ohm and 140W/4ohm. This amplifiers was tested against NCore 400 and in case of timbre, musicality, 3D stage, vocals and headroom, the VSSA amplifier is clear winner here 😎
- Status
- Not open for further replies.