Have the following parts available for the DCPP amp. Purchased sometime last year to build an amp for speakers/stax but they have just been laying around doing nothing since.
DCPP Amp
The three suggested transformers from Edcor.
1 x Blank PCB purchased from Pete Millett and then populated by me with the parts in the BOM.
4 x Upgraded Auricap 0.33uf 400V caps
0.22uf 1250V WIMA caps
A bunch of 250V 2A fuses
4 x Sylvania JAN 6CB6A
8 x RCA 6JN6 (different branding but confirmed with Pete a while back that they are rebranded RCA's)
IEC socket with fuse holder
There is an untouched Aluminium sheet from Online metals and one with all the holes punched in for the top plate that I gave to a machinist to paint black. For now only the untouched sheet is available. If the gentleman still has the one with the holes already done, I will send it out for the cost of shipping.
The transformers have never been mounted - the wires were never soldered. All the components that came from mouser/digikey were already soldered onto the board so I guess that saves a bit of time.
To my knowledge it is everything one would need to put the amp together barring a chassis (top plate is included above).
The parts in totality cost me a bit north of $485. The hole punching cost $180.
I'd like to sell all of it for $350 + actual shipping and fees if any or best offer.
pictures available here -
DCPP - Imgur
DCPP Amp
The three suggested transformers from Edcor.
1 x Blank PCB purchased from Pete Millett and then populated by me with the parts in the BOM.
4 x Upgraded Auricap 0.33uf 400V caps
0.22uf 1250V WIMA caps
A bunch of 250V 2A fuses
4 x Sylvania JAN 6CB6A
8 x RCA 6JN6 (different branding but confirmed with Pete a while back that they are rebranded RCA's)
IEC socket with fuse holder
There is an untouched Aluminium sheet from Online metals and one with all the holes punched in for the top plate that I gave to a machinist to paint black. For now only the untouched sheet is available. If the gentleman still has the one with the holes already done, I will send it out for the cost of shipping.
The transformers have never been mounted - the wires were never soldered. All the components that came from mouser/digikey were already soldered onto the board so I guess that saves a bit of time.
To my knowledge it is everything one would need to put the amp together barring a chassis (top plate is included above).
The parts in totality cost me a bit north of $485. The hole punching cost $180.
I'd like to sell all of it for $350 + actual shipping and fees if any or best offer.
pictures available here -
DCPP - Imgur
the transformers will ship in one box. the glass will ship in another. and the board and odds and ends will ship in the third. lets cap shipping at $50 via usps. i will provide the receipt upon shipment. if there is any $ left over from the $50, i'll refund it back, any more than $50 and i'll cover it.
$400 and any fees gets everything to you.
$400 and any fees gets everything to you.
Last edited:
- Status
- Not open for further replies.