• The swap meet forum is for private non-commercial transactions. Only unmoderated members can post here.

    diyAudio provides this forum for the convenience of our members, but makes no warranty nor assumes any responsibility. We do not vet any members. Use of this facility is at your own risk. Customers can post any issues in those threads as long as it is done in a civil manner. All diyAudio rules about conduct apply and will be enforced.

FS: NHT XDa - DSP processor (DEQX) and 4-channel amplifier

Status
Not open for further replies.
Jump to Latest
S

spurzheim

Member
Joined 2007
#1
This is the nearly impossible to find amplifier / processor for the NHT XD (Stereophile Class-A) system. It works with the XDs monitors (still available on closeout from NHT) or the even better M60 monitors from NHT (also still available new). NHT made many more speakers for this processor/amp than they did processors, so there are lots of "orphan" speakers out there. This was by far the most expensive component of the $6000 system.

It combines a DEQX processor (current retail for a DEQX alone is $3000) with a 4-channel PowerPhysics Class-D amplifier.

I was keeping this as a backup, but it is time to sell it.

$1300, excluding delivery or PayPal fees.

NHT xdA Specifications :
Type DSP processor/Amplifier unit
Amplifier Power RMS 150W x 4
Amplifier Power Paek 300W x 4
Amplifier Input Impedance 10k ohms
THD @ 90 dB SPL <0.06% at full power
±1 dB response 20Hz - 35kHz
Input Connectors XLR, RCA
Output Connectors 2 x XLR, 2 x RCA and 8 x single banana jacks
Input Sensitivity 1.5V RMS
Control Unit Dimensions 2.8" x 17" x 15.7" (H x W x D)
Control Unit Weight 12.5lbs.
Controls Speaker boundary compensation, number of bass modules
Indicators Power, Standby, Fault

//////////

325218-nht_xda__dsp_processor_deqx_and_4channel_amplifier.jpg
 
Status
Not open for further replies.
Top Bottom