I used schematic from AN DAC KIT 1.1 but I modified solid state high volt rectifier to tube EZ-80 rectifier and used walt jung super regulator + spectral dms-20 instead of original supply.
All parts applied on single PCB (receiver + DAC + IV + tube + all supply)
I sale only full assembled PCB + transformer.
I ask for 315 USD shipping included.
My board included cs8414cs, ad1865n-k, ecc82, ez80, all digital and analog power supply.
I have only 2 set of PCBs
Thanks
Rubydac
All parts applied on single PCB (receiver + DAC + IV + tube + all supply)
I sale only full assembled PCB + transformer.
I ask for 315 USD shipping included.
My board included cs8414cs, ad1865n-k, ecc82, ez80, all digital and analog power supply.
I have only 2 set of PCBs
Thanks
Rubydac
My picture of DAC
I used Nichicon FW for 5V digital and +/- 5V analog supply also filaments rectifier, 0.47uF/400V spargue orange drop for tube output.
For analog filter I/V used RLC circuit, 1% resistor + 12mH separated coil + silver mica 0.01uF
EZ-80 for rectifer with PI stage filter which used 1K and 2.2 K resistors and rubycon 47uF/400V for filter capacitor.
For cathode bypass I used 330 ohms parallel with 220uF/25V phillips axial leed.
This's my hobby.
Thanks
Rubydac
I used Nichicon FW for 5V digital and +/- 5V analog supply also filaments rectifier, 0.47uF/400V spargue orange drop for tube output.
For analog filter I/V used RLC circuit, 1% resistor + 12mH separated coil + silver mica 0.01uF
EZ-80 for rectifer with PI stage filter which used 1K and 2.2 K resistors and rubycon 47uF/400V for filter capacitor.
For cathode bypass I used 330 ohms parallel with 220uF/25V phillips axial leed.
This's my hobby.
Thanks
Rubydac
Attachments
My schematic
This's a schematic of my DAC.
I learned from many thread of AD1865N-K from DiyAudio, now I worked on SMPS design department but I loved DIY and sometime I used a freetime for design about digital schematic such as DAC, Class-T, Wireless LAN.
Thanks for contact
Rubydac
This's a schematic of my DAC.
I learned from many thread of AD1865N-K from DiyAudio, now I worked on SMPS design department but I loved DIY and sometime I used a freetime for design about digital schematic such as DAC, Class-T, Wireless LAN.
Thanks for contact
Rubydac
Attachments
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.