Hi All,
Found more stuff that I am unlikely to use anytime soon...
A pair of amp modules from an adcom 535 II, plus the case.
These modules do NOT have the original heatsinks attached, actually they have half, the heatsink was cut off to allow a low profile installation.
The distortion and thermal shutdown LEDS are attached.
IIRC they were supplied with +/- 55v, with 150-200va transformer per channel, ~5600uF per rail, per channel.
Both have the additional output transistors that would have been present if the modules had originated in the 545 II.
Both have been tested and work, apparently perfectly. I have not performed measurements to verify offset or bias levels etc. These have been stored for years and as such should be checked to make sure the adjustments are set correctly.
Very conservatively rated at 60w RMS, with the additional transistors and a bigger power supply they are used to deliver 100w RMS in the 545 II.
$60 for the pair. Plus I'll include rectifiers and caps to allow a constructor to get a headstart on the power supply.
I also have the case they were removed from, but all it's internals have been removed : $20
payment via any normal means but nothing leaves until payment has cleared...I'd prefer paypal.
Shipping is at cost to anyplace you are prepared to pay for.
Pictures to follow...
Found more stuff that I am unlikely to use anytime soon...
A pair of amp modules from an adcom 535 II, plus the case.
These modules do NOT have the original heatsinks attached, actually they have half, the heatsink was cut off to allow a low profile installation.
The distortion and thermal shutdown LEDS are attached.
IIRC they were supplied with +/- 55v, with 150-200va transformer per channel, ~5600uF per rail, per channel.
Both have the additional output transistors that would have been present if the modules had originated in the 545 II.
Both have been tested and work, apparently perfectly. I have not performed measurements to verify offset or bias levels etc. These have been stored for years and as such should be checked to make sure the adjustments are set correctly.
Very conservatively rated at 60w RMS, with the additional transistors and a bigger power supply they are used to deliver 100w RMS in the 545 II.
$60 for the pair. Plus I'll include rectifiers and caps to allow a constructor to get a headstart on the power supply.
I also have the case they were removed from, but all it's internals have been removed : $20
payment via any normal means but nothing leaves until payment has cleared...I'd prefer paypal.
Shipping is at cost to anyplace you are prepared to pay for.
Pictures to follow...
- Status
- Not open for further replies.