Hello!
I have a d type for-x amplifier model no: x6000.1
I searched original service manual. I'll be glad, if you help me
(I'm sorry for my bad english)🙂
Thank you
Regards.
I have a d type for-x amplifier model no: x6000.1
I searched original service manual. I'll be glad, if you help me
(I'm sorry for my bad english)🙂
Thank you
Regards.
If you described the problem you're encountering, and perhaps attached photos of the device, there's a chance you might get more assistance.
Just a thought...
Just a thought...
Evrim… try attaching your images directly to the forum. None of your links appeared to work correctly.
How to attach images to your posts.
How to attach images to your posts.
As it appears to be a car audio amplifier, maybe a mod will move this thread into the right forum.
I don't have anything that's exactly the same. What sort of problem are you having?
Does this driver board have two IR21844S driver ICs?
Does this driver board have two IR21844S driver ICs?
Yes, ı have two IR21844S driver ICs
I researched a little bit and realized that this amp was similar. Emphaser EA 13000 SPL
I researched a little bit and realized that this amp was similar. Emphaser EA 13000 SPL
I changed the mosquets on the amplifier's power circuit. I looked at the clarity of the square wave with the help of an oscilloscope. I got +/- 120 volts from the FMU32U diode. On the IRFP250N terminals, I normally see + 120V in the first third and -120V in the last third, but in the last three I see an extra -120V in the terminal. This is my problem and I can't find the solution.
Why do you keep posting images off-forum after being asked to post them properly? The threads here aren't solely for the OP. They are here to help others as well. Posting the images properly allows others to benefit from the help you're receiving.
- Status
- Not open for further replies.