Sorry, I wasnt very clear. I didn't mean paste the entire board I was referring to cleaning the copper with a flux and washing it prior to soldering.
I've never even considered washing the completed board in ways mentioned here, especially using water but then thats what this forum is about, considering the un-considered...if that makes any sense. Thanks a bunch for the help everyone, I'll definitely be adding a good cleaning step to the process from now on. I'm embarrassed to have a project fail in this manner.
I've never even considered washing the completed board in ways mentioned here, especially using water but then thats what this forum is about, considering the un-considered...if that makes any sense. Thanks a bunch for the help everyone, I'll definitely be adding a good cleaning step to the process from now on. I'm embarrassed to have a project fail in this manner.
I wouldn't be embarrassed... I have a few projects about that I never cleaned and that has not happened to me. Now you know that it could have been a factor.
- Status
- Not open for further replies.