Such gret info
Hi,
I just came from bsmt assembling a second stereo
amp for a friend. Last time I touched these boards was few good years ago and I did not ran into this. Now as soon I touched the input with the screwdriver the 100 (it says 100 ohm) resistor burned out.
Tomorrow I will replace the 100 ohm by the input with 3.1k Ko
A question though, which is R6 10 ohm that got burned
in the reference design schematic numerotation at page 30. Thank you
https://www.infineon.com/dgdl/iraudamp7s.pdf?fileId=5546d462533600a40153569addc92bfb
Hi,
I just came from bsmt assembling a second stereo
amp for a friend. Last time I touched these boards was few good years ago and I did not ran into this. Now as soon I touched the input with the screwdriver the 100 (it says 100 ohm) resistor burned out.
Tomorrow I will replace the 100 ohm by the input with 3.1k Ko
A question though, which is R6 10 ohm that got burned
in the reference design schematic numerotation at page 30. Thank you
https://www.infineon.com/dgdl/iraudamp7s.pdf?fileId=5546d462533600a40153569addc92bfb
Last edited:
On another bard
On a board form bangood both resistors
R13 and R14
Is this ok ?
On a board form bangood both resistors
R13 and R14
An externally hosted image should be here but it was not working when we last tested it.
are 0 Zero Ohms.Is this ok ?
Last edited:
Hi all,
I buy this amp. But my amp overheat after connect yhe the speaker. Found 1 small inductor show 220 code. Can this inductor give effect?
I buy this amp. But my amp overheat after connect yhe the speaker. Found 1 small inductor show 220 code. Can this inductor give effect?