Hi all. I'm in the process of building my first crossover and before I go and start laying out and drilling, I was hoping that someone could confirm if I've wired this properly per the schematic (done by Solen). I know the arrangement of the parts is way wrong but I just want to confirm that my tie points are correct.
Since I'll be fine tuning values and upgrading caps, I'll likely use terminal strips like Troels Graveson to facilitate easy swapping. Like I said, this is my first build, so would be so grateful for a confirmation. Thanks
Since I'll be fine tuning values and upgrading caps, I'll likely use terminal strips like Troels Graveson to facilitate easy swapping. Like I said, this is my first build, so would be so grateful for a confirmation. Thanks
Attachments
I think so.
You will have to double check your negative returns are all hooked up as required. I couldn't see how you are terminating the Lpad, so don't forget that.
Also worth noting the tweeter is wired in the opposite phase.
Maybe a bit more context about the design would help others understand what is going on here, with the notches and the cryptic comments on the crossover information sheet. Whose design is it, is it an open baffle or cabinet design etc?
You will have to double check your negative returns are all hooked up as required. I couldn't see how you are terminating the Lpad, so don't forget that.
Also worth noting the tweeter is wired in the opposite phase.
Maybe a bit more context about the design would help others understand what is going on here, with the notches and the cryptic comments on the crossover information sheet. Whose design is it, is it an open baffle or cabinet design etc?