You can find the T/S parameters by useing a proper software and a good microphone connected to your soundcard.Although this is not so simple i think it's worth spending some time.I havent yet deal with it so i can't tell you detailes haw to do this if you want.I am planing to learn more when i find the free time.
Regards George
Regards George
No Theile-Small parameters do not require a mic at all. However, a mic can be useful for measuring other stuff 🙂
This is what i am talking about : http://www.audua.com/SW/Project/Monitor Test Drivers.htm
I am not an expert at this. If i am mistaken pls correct me 🙂
I am not an expert at this. If i am mistaken pls correct me 🙂
enter said:
Yes that's exactly the sort of tests I'm on about. Now if you can show me where it uses a mic on that page I'll buy you a milkshake 😉
hi simon5, do you know if the corrected, T/S Paramaters for the Atlas 12 have been posted any where? i'd sure like to know what they are if so as i'm wanting to build a new vented enclosure for mine but, i can't seem to find any sites where they have been remeasured. parts express has a tester but, they are a little out of my price range. crippledchickensimon5 said:
🙂
If you have a PC, a DMM and a couple of resistors, you can use the method shown on Rod's page in the link above to make pretty good measurements. Much better than relying on someone else's. 🙂
Hi crippledchicken,
Long time no see!
No, Chad at Ascendant never remeasured the atlas.
No one else I know remeasured them.
Long time no see!
No, Chad at Ascendant never remeasured the atlas.
No one else I know remeasured them.
i just thought maybe they might of been changed and reposted since the old paramaters have been taken down. was thinking about building a new enclosure for my 12. good talking to you again, cheers 🙂
You'd be better measure them yourself I guess, like pinkmouse said!
Good luck and keep the DIY flame alive! 😉
Good luck and keep the DIY flame alive! 😉
- Status
- Not open for further replies.