FETs stage output Rockford Fosgate T10001BD

[Mjimenez]

What fets does it have in the output stage? rockford fosgate T10001bd with mixed fets on output stage
and someone have the schematic of this version?

 

[Don Hathcock]

Does this help?

 

[Mjimenez]

¿Esto ayuda?

Thank you

 

[Mjimenez]

Regarding the type of fets I have read in some forums that I should put the irfp3415... is it correct?

 

[Don Hathcock]

Perry Babin will be the one to ask. I do not have a lot of experience with the RF amps. The 4-channel RF I am working on now uses different mosfets in the front and rear channels.

 

[Perry Babin]

That's what's installed, in the photos of all of the T1000s that I have.

 

[Mjimenez]

Oky thanks Perry

 

[Mjimenez]

thanks, the T10001bd is already working... and last question, how can I wash the printed card? It is very dirty and I would like to leave it impeccable

 

[Perry Babin]

I 'carefully' use a pressure washer after spraying the board down with some sort of cleaner (409, Fantastic...).

The switches in these amps are dodgy under the best conditions. If you clean the board and get the switches wet, be sure to flush them thoroughly with some sort of contact cleaner. The pots are harder to flush so you may want to wrap them to prevent them getting wet.

If you do this, make absolutely sure that it's completely dry before powering it up again.