Hello everyone, yesterday i was changing the mid cap value in tone stack, put it back togheter now i have no reverb, i have checked
tubes
cables
reverb pan
the amp was working fine before this, the symptoms now are, i do hear the reverb springs if i tap the pan, but its very very low volume, the reverb knob doesn’t affect nothing if you turn it, if someone can point me where to check first now ill be grateful, thanks a lot
tubes
cables
reverb pan
the amp was working fine before this, the symptoms now are, i do hear the reverb springs if i tap the pan, but its very very low volume, the reverb knob doesn’t affect nothing if you turn it, if someone can point me where to check first now ill be grateful, thanks a lot
Looks like the input wiring of the spring is broken. For my knowledge a multimeter should display several ohms on input jack.
Hello, thanks for reply, lets take out
tubes
pan
and cables
already checked with new of all tubes, new cable and also other reverb pan to be in good condition. None of that its the problem.
im already looking at the inside, im suspecting on C14, R29, im not getting correct readings, any help would be great, thanks
tubes
pan
and cables
already checked with new of all tubes, new cable and also other reverb pan to be in good condition. None of that its the problem.
im already looking at the inside, im suspecting on C14, R29, im not getting correct readings, any help would be great, thanks
SOLVED/ i had to go to the board, C16 had both legs broken from the trail, i might pushed somehow when i was soldering the tone stack, anyways that was it.