I didn't pass on them. Got 2 pairs!
Only built one channel though.
Too many amps, so little time.
Rush
i said the same thing. but he insisted😀 the reason for cutting them is heat.
in this manner, i can get the heat spread more even across the 2x 10.080" heatsinks. so they can handle the 250W dissipation🙂 pr ch.
i dont know obout that. i found several foults when i studied the boards prior to production🙂 it was all mislabeling. but still.
and that was from the last drawings out there.
and that was from the last drawings out there.
I know for a fact boards are on their way from the store. You will have satisfaction soon. I could build a bridge by now. Amps are harder😀
Here is the most wanted person, I continue seated waiting PSU F5T2. 
http://www.diyaudio.com/forums/tubes-valves/151421-26-pre-amp-225.html
http://www.diyaudio.com/forums/tubes-valves/151421-26-pre-amp-225.html
How about these? Got them in yesterday afternoon!
I've got 3 people signed up to build them to make sure they work perfectly but don't know how long they'll take. However if a lot of people want boardsets and are willing to take them "as is" then we could probably let a few more go.
If there turns out to be something wrong with the boards, you would have to either mod them, or order replacement boards which we could supply at a reasonable cost plus shipping. Of course since there are 3 board types, the gain board which can be snapped in half, and a P channel output bd. and an N ch. one, it's unlikely that more then one would be bad..
We're planning to sell the boards as a set - one 2ch gain stage bd. and 2 N ch output bds and 2 p ch output bds.
Anyway- enjoy the view!
Mark
We recommend waiting!
I've got 3 people signed up to build them to make sure they work perfectly but don't know how long they'll take. However if a lot of people want boardsets and are willing to take them "as is" then we could probably let a few more go.
If there turns out to be something wrong with the boards, you would have to either mod them, or order replacement boards which we could supply at a reasonable cost plus shipping. Of course since there are 3 board types, the gain board which can be snapped in half, and a P channel output bd. and an N ch. one, it's unlikely that more then one would be bad..
We're planning to sell the boards as a set - one 2ch gain stage bd. and 2 N ch output bds and 2 p ch output bds.
Anyway- enjoy the view!
Mark
We recommend waiting!
Attachments
Last edited:
Rush, Thats red and gold. Maybe you should get your head checked out!😉
I knew it was gold, it kind of looked green as I am in the Christmas spirit.
I am green with envy.
Rush
- Status
- Not open for further replies.