These were built (and signed) by Bruce himself in the mid 1990's. They are for a midrange compression driver. Never used. I can send pictures. Asking $125 + shipping.
These were built (and signed) by Bruce himself in the mid 1990's. They are for a midrange compression driver. Never used. I can send pictures. Asking $125 + shipping.
Can you post a picture or two?
Hope this works! If not, the flickr link should get you there.
An externally hosted image should be here but it was not working when we last tested it.
An externally hosted image should be here but it was not working when we last tested it.
Sorry but I can't seem to get the pictures to show.
I put them on my flickr page:
Edgar2 | Flickr - Photo Sharing!
I think that should work.
I put them on my flickr page:
Edgar2 | Flickr - Photo Sharing!
I think that should work.
...never mind the horns, nice plug for your portfolio! You are a fantastic photographer! I would be very proud to frame each and every shot!
Bravo!
Bravo!
Agreed, beautiful photography page. You have an eye for detail and colour and the shots capture the light perfectly. What sort of camera and lens do you use?
Regards,
Steve.
Regards,
Steve.
As you can see from the above message the horns are sold.
There was a lot of interest in them (almost 1000 hits on Flickr)!
I do want to correct a mistaken notion I stated in the original listing. The recommended driver is a vintage alnico JBL LE5-2.
Thanks for the kind comments on the photos. I am just a casual amateur using a Nikon D200 and 18-200mm Nikon lens. The camera and Boston gets most of the credit if the pictures look good!
_____________________
Ron
There was a lot of interest in them (almost 1000 hits on Flickr)!
I do want to correct a mistaken notion I stated in the original listing. The recommended driver is a vintage alnico JBL LE5-2.
Thanks for the kind comments on the photos. I am just a casual amateur using a Nikon D200 and 18-200mm Nikon lens. The camera and Boston gets most of the credit if the pictures look good!
_____________________
Ron
- Status
- Not open for further replies.